!C99Shell v. 2.0 [PHP 7 Update] [25.02.2019]!

Software: nginx/1.23.4. PHP/5.6.40-65+ubuntu20.04.1+deb.sury.org+1 

uname -a: Linux foro-restaurado-2 5.15.0-1040-oracle #46-Ubuntu SMP Fri Jul 14 21:47:21 UTC 2023
aarch64
 

uid=33(www-data) gid=33(www-data) groups=33(www-data) 

Safe-mode: OFF (not secure)

/usr/src/linux-oracle-5.13-headers-5.13.0-1018/include/scsi/fc/   drwxr-xr-x
Free 83.24 GB of 96.73 GB (86.06%)
Home    Back    Forward    UPDIR    Refresh    Search    Buffer    Encoder    Tools    Proc.    FTP brute    Sec.    SQL    PHP-code    Update    Feedback    Self remove    Logout    


Viewing file:     fc_fcp.h (6.33 KB)      -rw-r--r--
Select action/file-type:
(+) | (+) | (+) | Code (+) | Session (+) | (+) | SDB (+) | (+) | (+) | (+) | (+) | (+) |
/* SPDX-License-Identifier: GPL-2.0-only */
/*
 * Copyright(c) 2007 Intel Corporation. All rights reserved.
 *
 * Maintained at www.Open-FCoE.org
 */

#ifndef _FC_FCP_H_
#define    _FC_FCP_H_

#include <scsi/scsi.h>

/*
 * Fibre Channel Protocol for SCSI.
 * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
 */

/*
 * fc/fs.h defines FC_TYPE_FCP.
 */

/*
 * Service parameter page parameters (word 3 bits) for Process Login.
 */
#define    FCP_SPPF_TASK_RETRY_ID    0x0200    /* task retry ID requested */
#define    FCP_SPPF_RETRY        0x0100    /* retry supported */
#define    FCP_SPPF_CONF_COMPL    0x0080    /* confirmed completion allowed */
#define    FCP_SPPF_OVLY_ALLOW    0x0040    /* data overlay allowed */
#define    FCP_SPPF_INIT_FCN    0x0020    /* initiator function */
#define    FCP_SPPF_TARG_FCN    0x0010    /* target function */
#define    FCP_SPPF_RD_XRDY_DIS    0x0002    /* disable XFER_RDY for reads */
#define    FCP_SPPF_WR_XRDY_DIS    0x0001    /* disable XFER_RDY for writes */

/*
 * FCP_CMND IU Payload.
 */
struct fcp_cmnd {
    struct scsi_lun    fc_lun;        /* logical unit number */
    __u8        fc_cmdref;    /* command reference number */
    __u8        fc_pri_ta;    /* priority and task attribute */
    __u8        fc_tm_flags;    /* task management flags */
    __u8        fc_flags;    /* additional len & flags */
    __u8        fc_cdb[16];    /* base CDB */
    __be32        fc_dl;        /* data length (must follow fc_cdb) */
};

#define    FCP_CMND_LEN    32    /* expected length of structure */

struct fcp_cmnd32 {
    struct scsi_lun    fc_lun;        /* logical unit number */
    __u8        fc_cmdref;    /* command reference number */
    __u8        fc_pri_ta;    /* priority and task attribute */
    __u8        fc_tm_flags;    /* task management flags */
    __u8        fc_flags;    /* additional len & flags */
    __u8        fc_cdb[32];    /* base CDB */
    __be32        fc_dl;        /* data length (must follow fc_cdb) */
};

#define    FCP_CMND32_LEN        48    /* expected length of structure */
#define    FCP_CMND32_ADD_LEN  (16 / 4)    /* Additional cdb length */

/*
 * fc_pri_ta.
 */
#define    FCP_PTA_SIMPLE        0    /* simple task attribute */
#define    FCP_PTA_HEADQ        1    /* head of queue task attribute */
#define    FCP_PTA_ORDERED     2    /* ordered task attribute */
#define    FCP_PTA_ACA        4    /* auto. contingent allegiance */
#define    FCP_PTA_MASK        7    /* mask for task attribute field */
#define    FCP_PRI_SHIFT        3    /* priority field starts in bit 3 */
#define    FCP_PRI_RESVD_MASK  0x80    /* reserved bits in priority field */

/*
 * fc_tm_flags - task management flags field.
 */
#define    FCP_TMF_CLR_ACA        0x40    /* clear ACA condition */
#define    FCP_TMF_TGT_RESET    0x20    /* target reset task management,
                       deprecated as of FCP-3 */
#define    FCP_TMF_LUN_RESET    0x10    /* logical unit reset task management */
#define    FCP_TMF_CLR_TASK_SET    0x04    /* clear task set */
#define    FCP_TMF_ABT_TASK_SET    0x02    /* abort task set */

/*
 * fc_flags.
 *  Bits 7:2 are the additional FCP_CDB length / 4.
 */
#define    FCP_CFL_LEN_MASK    0xfc    /* mask for additional length */
#define    FCP_CFL_LEN_SHIFT    2    /* shift bits for additional length */
#define    FCP_CFL_RDDATA        0x02    /* read data */
#define    FCP_CFL_WRDATA        0x01    /* write data */

/*
 * FCP_TXRDY IU - transfer ready payload.
 */
struct fcp_txrdy {
    __be32        ft_data_ro;    /* data relative offset */
    __be32        ft_burst_len;    /* burst length */
    __u8        _ft_resvd[4];    /* reserved */
};

#define    FCP_TXRDY_LEN    12    /* expected length of structure */

/*
 * FCP_RESP IU - response payload.
 *
 * The response payload comes in three parts: the flags/status, the
 * sense/response lengths and the sense data/response info section.
 *
 * From FCP3r04, note 6 of section 9.5.13:
 *
 * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
 * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
 * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
 * non-standard behavior should be tolerated.
 *
 * All response frames will always contain the fcp_resp template.  Some
 * will also include the fcp_resp_len template.
 *
 * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
 * are valid length.
 */
struct fcp_resp {
    __u8        _fr_resvd[8];    /* reserved */
    __be16        fr_retry_delay;    /* retry delay timer */
    __u8        fr_flags;    /* flags */
    __u8        fr_status;    /* SCSI status code */
};

#define    FCP_RESP_LEN    12    /* expected length of structure */

struct fcp_resp_ext {
    __be32        fr_resid;    /* Residual value */
    __be32        fr_sns_len;    /* SCSI Sense length */
    __be32        fr_rsp_len;    /* Response Info length */

    /*
     * Optionally followed by RSP info and/or SNS info and/or
     * bidirectional read residual length, if any.
     */
};

#define FCP_RESP_EXT_LEN    12  /* expected length of the structure */

struct fcp_resp_rsp_info {
    __u8      _fr_resvd[3];       /* reserved */
    __u8      rsp_code;           /* Response Info Code */
    __u8      _fr_resvd2[4];      /* reserved */
};

#define FCP_RESP_RSP_INFO_LEN4    4 /* without reserved field */
#define FCP_RESP_RSP_INFO_LEN8    8 /* with reserved field */

struct fcp_resp_with_ext {
    struct fcp_resp resp;
    struct fcp_resp_ext ext;
};

#define    FCP_RESP_WITH_EXT   (FCP_RESP_LEN + FCP_RESP_EXT_LEN)

/*
 * fr_flags.
 */
#define    FCP_BIDI_RSP        0x80    /* bidirectional read response */
#define    FCP_BIDI_READ_UNDER 0x40    /* bidir. read less than requested */
#define    FCP_BIDI_READ_OVER  0x20    /* DL insufficient for full transfer */
#define    FCP_CONF_REQ        0x10    /* confirmation requested */
#define    FCP_RESID_UNDER     0x08    /* transfer shorter than expected */
#define    FCP_RESID_OVER        0x04    /* DL insufficient for full transfer */
#define    FCP_SNS_LEN_VAL     0x02    /* SNS_LEN field is valid */
#define    FCP_RSP_LEN_VAL     0x01    /* RSP_LEN field is valid */

/*
 * rsp_codes
 */
enum fcp_resp_rsp_codes {
    FCP_TMF_CMPL = 0,
    FCP_DATA_LEN_INVALID = 1,
    FCP_CMND_FIELDS_INVALID = 2,
    FCP_DATA_PARAM_MISMATCH = 3,
    FCP_TMF_REJECTED = 4,
    FCP_TMF_FAILED = 5,
    FCP_TMF_INVALID_LUN = 9,
};

/*
 * FCP SRR Link Service request - Sequence Retransmission Request.
 */
struct fcp_srr {
    __u8        srr_op;        /* opcode ELS_SRR */
    __u8        srr_resvd[3];    /* opcode / reserved - must be zero */
    __be16        srr_ox_id;    /* OX_ID of failed command */
    __be16        srr_rx_id;    /* RX_ID of failed command */
    __be32        srr_rel_off;    /* relative offset */
    __u8        srr_r_ctl;    /* r_ctl for the information unit */
    __u8        srr_resvd2[3];    /* reserved */
};

/*
 * Feature bits in name server FC-4 Features object.
 */
#define    FCP_FEAT_TARG    (1 << 0)    /* target function supported */
#define    FCP_FEAT_INIT    (1 << 1)    /* initiator function supported */

#endif /* _FC_FCP_H_ */

:: Command execute ::

Enter:
 
Select:
 

:: Search ::
  - regexp 

:: Upload ::
 
[ Read-Only ]

:: Make Dir ::
 
[ Read-Only ]
:: Make File ::
 
[ Read-Only ]

:: Go Dir ::
 
:: Go File ::
 

--[ c99shell v. 2.0 [PHP 7 Update] [25.02.2019] maintained by HackingTool | HackingTool | Generation time: 0.0047 ]--