Viewing file:  outercache.h (3.19 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0-only */
/*
* arch/arm/include/asm/outercache.h
*
* Copyright (C) 2010 ARM Ltd.
* Written by Catalin Marinas <[email protected]>
*/
#ifndef __ASM_OUTERCACHE_H
#define __ASM_OUTERCACHE_H
#include <linux/types.h>
struct l2x0_regs;
struct outer_cache_fns {
void (*inv_range)(unsigned long, unsigned long);
void (*clean_range)(unsigned long, unsigned long);
void (*flush_range)(unsigned long, unsigned long);
void (*flush_all)(void);
void (*disable)(void);
#ifdef CONFIG_OUTER_CACHE_SYNC
void (*sync)(void);
#endif
void (*resume)(void);
/* This is an ARM L2C thing */
void (*write_sec)(unsigned long, unsigned);
void (*configure)(const struct l2x0_regs *);
};
extern struct outer_cache_fns outer_cache;
#ifdef CONFIG_OUTER_CACHE
/**
* outer_inv_range - invalidate range of outer cache lines
* @start: starting physical address, inclusive
* @end: end physical address, exclusive
*/
static inline void outer_inv_range(phys_addr_t start, phys_addr_t end)
{
if (outer_cache.inv_range)
outer_cache.inv_range(start, end);
}
/**
* outer_clean_range - clean dirty outer cache lines
* @start: starting physical address, inclusive
* @end: end physical address, exclusive
*/
static inline void outer_clean_range(phys_addr_t start, phys_addr_t end)
{
if (outer_cache.clean_range)
outer_cache.clean_range(start, end);
}
/**
* outer_flush_range - clean and invalidate outer cache lines
* @start: starting physical address, inclusive
* @end: end physical address, exclusive
*/
static inline void outer_flush_range(phys_addr_t start, phys_addr_t end)
{
if (outer_cache.flush_range)
outer_cache.flush_range(start, end);
}
/**
* outer_flush_all - clean and invalidate all cache lines in the outer cache
*
* Note: depending on implementation, this may not be atomic - it must
* only be called with interrupts disabled and no other active outer
* cache masters.
*
* It is intended that this function is only used by implementations
* needing to override the outer_cache.disable() method due to security.
* (Some implementations perform this as a clean followed by an invalidate.)
*/
static inline void outer_flush_all(void)
{
if (outer_cache.flush_all)
outer_cache.flush_all();
}
/**
* outer_disable - clean, invalidate and disable the outer cache
*
* Disable the outer cache, ensuring that any data contained in the outer
* cache is pushed out to lower levels of system memory. The note and
* conditions above concerning outer_flush_all() applies here.
*/
extern void outer_disable(void);
/**
* outer_resume - restore the cache configuration and re-enable outer cache
*
* Restore any configuration that the cache had when previously enabled,
* and re-enable the outer cache.
*/
static inline void outer_resume(void)
{
if (outer_cache.resume)
outer_cache.resume();
}
#else
static inline void outer_inv_range(phys_addr_t start, phys_addr_t end)
{ }
static inline void outer_clean_range(phys_addr_t start, phys_addr_t end)
{ }
static inline void outer_flush_range(phys_addr_t start, phys_addr_t end)
{ }
static inline void outer_flush_all(void) { }
static inline void outer_disable(void) { }
static inline void outer_resume(void) { }
#endif
#endif /* __ASM_OUTERCACHE_H */
|