Viewing file:  shannon.h (1.87 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef _INCLUDE_SHANNON_H
#define _INCLUDE_SHANNON_H
/* taken from comp.os.inferno Tue, 12 Sep 2000 09:21:50 GMT,
* written by <[email protected]> */
#define SHANNON_GPIO_SPI_FLASH GPIO_GPIO (0) /* Output - Driven low, enables SPI to flash */
#define SHANNON_GPIO_SPI_DSP GPIO_GPIO (1) /* Output - Driven low, enables SPI to DSP */
/* lcd lower = GPIO 2-9 */
#define SHANNON_GPIO_SPI_OUTPUT GPIO_GPIO (10) /* Output - SPI output to DSP */
#define SHANNON_GPIO_SPI_INPUT GPIO_GPIO (11) /* Input - SPI input from DSP */
#define SHANNON_GPIO_SPI_CLOCK GPIO_GPIO (12) /* Output - Clock for SPI */
#define SHANNON_GPIO_SPI_FRAME GPIO_GPIO (13) /* Output - Frame marker - not used */
#define SHANNON_GPIO_SPI_RTS GPIO_GPIO (14) /* Input - SPI Ready to Send */
#define SHANNON_IRQ_GPIO_SPI_RTS IRQ_GPIO14
#define SHANNON_GPIO_SPI_CTS GPIO_GPIO (15) /* Output - SPI Clear to Send */
#define SHANNON_GPIO_IRQ_CODEC GPIO_GPIO (16) /* in, irq from ucb1200 */
#define SHANNON_IRQ_GPIO_IRQ_CODEC IRQ_GPIO16
#define SHANNON_GPIO_DSP_RESET GPIO_GPIO (17) /* Output - Drive low to reset the DSP */
#define SHANNON_GPIO_CODEC_RESET GPIO_GPIO (18) /* Output - Drive low to reset the UCB1x00 */
#define SHANNON_GPIO_U3_RTS GPIO_GPIO (19) /* ?? */
#define SHANNON_GPIO_U3_CTS GPIO_GPIO (20) /* ?? */
#define SHANNON_GPIO_SENSE_12V GPIO_GPIO (21) /* Input, 12v flash unprotect detected */
#define SHANNON_GPIO_DISP_EN 22 /* out */
/* XXX GPIO 23 unaccounted for */
#define SHANNON_GPIO_EJECT_0 24 /* in */
#define SHANNON_GPIO_EJECT_1 25 /* in */
#define SHANNON_GPIO_RDY_0 26 /* in */
#define SHANNON_GPIO_RDY_1 27 /* in */
/* MCP UCB codec GPIO pins... */
#define SHANNON_UCB_GPIO_BACKLIGHT 9
#define SHANNON_UCB_GPIO_BRIGHT_MASK 7
#define SHANNON_UCB_GPIO_BRIGHT 6
#define SHANNON_UCB_GPIO_CONTRAST_MASK 0x3f
#define SHANNON_UCB_GPIO_CONTRAST 0
#endif
|