Viewing file:  io-unit.h (2.41 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0 */
/* io-unit.h: Definitions for the sun4d IO-UNIT.
*
* Copyright (C) 1997,1998 Jakub Jelinek ([email protected])
*/
#ifndef _SPARC_IO_UNIT_H
#define _SPARC_IO_UNIT_H
#include <linux/spinlock.h>
#include <linux/pgtable.h>
#include <asm/page.h>
/* The io-unit handles all virtual to physical address translations
* that occur between the SBUS and physical memory. Access by
* the cpu to IO registers and similar go over the xdbus so are
* translated by the on chip SRMMU. The io-unit and the srmmu do
* not need to have the same translations at all, in fact most
* of the time the translations they handle are a disjunct set.
* Basically the io-unit handles all dvma sbus activity.
*/
/* AIEEE, unlike the nice sun4m, these monsters have
fixed DMA range 64M */
#define IOUNIT_DMA_BASE 0xfc000000 /* TOP - 64M */
#define IOUNIT_DMA_SIZE 0x04000000 /* 64M */
/* We use last 1M for sparc_dvma_malloc */
#define IOUNIT_DVMA_SIZE 0x00100000 /* 1M */
/* The format of an iopte in the external page tables */
#define IOUPTE_PAGE 0xffffff00 /* Physical page number (PA[35:12]) */
#define IOUPTE_CACHE 0x00000080 /* Cached (in Viking/MXCC) */
/* XXX Jakub, find out how to program SBUS streaming cache on XDBUS/sun4d.
* XXX Actually, all you should need to do is find out where the registers
* XXX are and copy over the sparc64 implementation I wrote. There may be
* XXX some horrible hwbugs though, so be careful. -DaveM
*/
#define IOUPTE_STREAM 0x00000040 /* Translation can use streaming cache */
#define IOUPTE_INTRA 0x00000008 /* SBUS direct slot->slot transfer */
#define IOUPTE_WRITE 0x00000004 /* Writeable */
#define IOUPTE_VALID 0x00000002 /* IOPTE is valid */
#define IOUPTE_PARITY 0x00000001 /* Parity is checked during DVMA */
struct iounit_struct {
unsigned long bmap[(IOUNIT_DMA_SIZE >> (PAGE_SHIFT + 3)) / sizeof(unsigned long)];
spinlock_t lock;
iopte_t __iomem *page_table;
unsigned long rotor[3];
unsigned long limit[4];
};
#define IOUNIT_BMAP1_START 0x00000000
#define IOUNIT_BMAP1_END (IOUNIT_DMA_SIZE >> (PAGE_SHIFT + 1))
#define IOUNIT_BMAP2_START IOUNIT_BMAP1_END
#define IOUNIT_BMAP2_END IOUNIT_BMAP2_START + (IOUNIT_DMA_SIZE >> (PAGE_SHIFT + 2))
#define IOUNIT_BMAPM_START IOUNIT_BMAP2_END
#define IOUNIT_BMAPM_END ((IOUNIT_DMA_SIZE - IOUNIT_DVMA_SIZE) >> PAGE_SHIFT)
#endif /* !(_SPARC_IO_UNIT_H) */
|