Viewing file:  stpmic1.h (5.62 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0 */
/*
* Copyright (C) STMicroelectronics 2018 - All Rights Reserved
* Author: Philippe Peurichard <[email protected]>,
* Pascal Paillet <[email protected]> for STMicroelectronics.
*/
#ifndef __LINUX_MFD_STPMIC1_H
#define __LINUX_MFD_STPMIC1_H
#define TURN_ON_SR 0x1
#define TURN_OFF_SR 0x2
#define ICC_LDO_TURN_OFF_SR 0x3
#define ICC_BUCK_TURN_OFF_SR 0x4
#define RREQ_STATE_SR 0x5
#define VERSION_SR 0x6
#define SWOFF_PWRCTRL_CR 0x10
#define PADS_PULL_CR 0x11
#define BUCKS_PD_CR 0x12
#define LDO14_PD_CR 0x13
#define LDO56_VREF_PD_CR 0x14
#define VBUS_DET_VIN_CR 0x15
#define PKEY_TURNOFF_CR 0x16
#define BUCKS_MASK_RANK_CR 0x17
#define BUCKS_MASK_RESET_CR 0x18
#define LDOS_MASK_RANK_CR 0x19
#define LDOS_MASK_RESET_CR 0x1A
#define WCHDG_CR 0x1B
#define WCHDG_TIMER_CR 0x1C
#define BUCKS_ICCTO_CR 0x1D
#define LDOS_ICCTO_CR 0x1E
#define BUCK1_ACTIVE_CR 0x20
#define BUCK2_ACTIVE_CR 0x21
#define BUCK3_ACTIVE_CR 0x22
#define BUCK4_ACTIVE_CR 0x23
#define VREF_DDR_ACTIVE_CR 0x24
#define LDO1_ACTIVE_CR 0x25
#define LDO2_ACTIVE_CR 0x26
#define LDO3_ACTIVE_CR 0x27
#define LDO4_ACTIVE_CR 0x28
#define LDO5_ACTIVE_CR 0x29
#define LDO6_ACTIVE_CR 0x2A
#define BUCK1_STDBY_CR 0x30
#define BUCK2_STDBY_CR 0x31
#define BUCK3_STDBY_CR 0x32
#define BUCK4_STDBY_CR 0x33
#define VREF_DDR_STDBY_CR 0x34
#define LDO1_STDBY_CR 0x35
#define LDO2_STDBY_CR 0x36
#define LDO3_STDBY_CR 0x37
#define LDO4_STDBY_CR 0x38
#define LDO5_STDBY_CR 0x39
#define LDO6_STDBY_CR 0x3A
#define BST_SW_CR 0x40
#define INT_PENDING_R1 0x50
#define INT_PENDING_R2 0x51
#define INT_PENDING_R3 0x52
#define INT_PENDING_R4 0x53
#define INT_DBG_LATCH_R1 0x60
#define INT_DBG_LATCH_R2 0x61
#define INT_DBG_LATCH_R3 0x62
#define INT_DBG_LATCH_R4 0x63
#define INT_CLEAR_R1 0x70
#define INT_CLEAR_R2 0x71
#define INT_CLEAR_R3 0x72
#define INT_CLEAR_R4 0x73
#define INT_MASK_R1 0x80
#define INT_MASK_R2 0x81
#define INT_MASK_R3 0x82
#define INT_MASK_R4 0x83
#define INT_SET_MASK_R1 0x90
#define INT_SET_MASK_R2 0x91
#define INT_SET_MASK_R3 0x92
#define INT_SET_MASK_R4 0x93
#define INT_CLEAR_MASK_R1 0xA0
#define INT_CLEAR_MASK_R2 0xA1
#define INT_CLEAR_MASK_R3 0xA2
#define INT_CLEAR_MASK_R4 0xA3
#define INT_SRC_R1 0xB0
#define INT_SRC_R2 0xB1
#define INT_SRC_R3 0xB2
#define INT_SRC_R4 0xB3
#define PMIC_MAX_REGISTER_ADDRESS INT_SRC_R4
#define STPMIC1_PMIC_NUM_IRQ_REGS 4
#define TURN_OFF_SR_ICC_EVENT 0x08
#define LDO_VOLTAGE_MASK GENMASK(6, 2)
#define BUCK_VOLTAGE_MASK GENMASK(7, 2)
#define LDO_BUCK_VOLTAGE_SHIFT 2
#define LDO_ENABLE_MASK BIT(0)
#define BUCK_ENABLE_MASK BIT(0)
#define BUCK_HPLP_ENABLE_MASK BIT(1)
#define BUCK_HPLP_SHIFT 1
#define STDBY_ENABLE_MASK BIT(0)
#define BUCKS_PD_CR_REG_MASK GENMASK(7, 0)
#define BUCK_MASK_RANK_REGISTER_MASK GENMASK(3, 0)
#define BUCK_MASK_RESET_REGISTER_MASK GENMASK(3, 0)
#define LDO1234_PULL_DOWN_REGISTER_MASK GENMASK(7, 0)
#define LDO56_VREF_PD_CR_REG_MASK GENMASK(5, 0)
#define LDO_MASK_RANK_REGISTER_MASK GENMASK(5, 0)
#define LDO_MASK_RESET_REGISTER_MASK GENMASK(5, 0)
#define BUCK1_PULL_DOWN_REG BUCKS_PD_CR
#define BUCK1_PULL_DOWN_MASK BIT(0)
#define BUCK2_PULL_DOWN_REG BUCKS_PD_CR
#define BUCK2_PULL_DOWN_MASK BIT(2)
#define BUCK3_PULL_DOWN_REG BUCKS_PD_CR
#define BUCK3_PULL_DOWN_MASK BIT(4)
#define BUCK4_PULL_DOWN_REG BUCKS_PD_CR
#define BUCK4_PULL_DOWN_MASK BIT(6)
#define LDO1_PULL_DOWN_REG LDO14_PD_CR
#define LDO1_PULL_DOWN_MASK BIT(0)
#define LDO2_PULL_DOWN_REG LDO14_PD_CR
#define LDO2_PULL_DOWN_MASK BIT(2)
#define LDO3_PULL_DOWN_REG LDO14_PD_CR
#define LDO3_PULL_DOWN_MASK BIT(4)
#define LDO4_PULL_DOWN_REG LDO14_PD_CR
#define LDO4_PULL_DOWN_MASK BIT(6)
#define LDO5_PULL_DOWN_REG LDO56_VREF_PD_CR
#define LDO5_PULL_DOWN_MASK BIT(0)
#define LDO6_PULL_DOWN_REG LDO56_VREF_PD_CR
#define LDO6_PULL_DOWN_MASK BIT(2)
#define VREF_DDR_PULL_DOWN_REG LDO56_VREF_PD_CR
#define VREF_DDR_PULL_DOWN_MASK BIT(4)
#define BUCKS_ICCTO_CR_REG_MASK GENMASK(6, 0)
#define LDOS_ICCTO_CR_REG_MASK GENMASK(5, 0)
#define LDO_BYPASS_MASK BIT(7)
/* Main PMIC Control Register
* SWOFF_PWRCTRL_CR
* Address : 0x10
*/
#define ICC_EVENT_ENABLED BIT(4)
#define PWRCTRL_POLARITY_HIGH BIT(3)
#define PWRCTRL_PIN_VALID BIT(2)
#define RESTART_REQUEST_ENABLED BIT(1)
#define SOFTWARE_SWITCH_OFF_ENABLED BIT(0)
/* Main PMIC PADS Control Register
* PADS_PULL_CR
* Address : 0x11
*/
#define WAKEUP_DETECTOR_DISABLED BIT(4)
#define PWRCTRL_PD_ACTIVE BIT(3)
#define PWRCTRL_PU_ACTIVE BIT(2)
#define WAKEUP_PD_ACTIVE BIT(1)
#define PONKEY_PU_INACTIVE BIT(0)
/* Main PMIC VINLOW Control Register
* VBUS_DET_VIN_CRC DMSC
* Address : 0x15
*/
#define SWIN_DETECTOR_ENABLED BIT(7)
#define SWOUT_DETECTOR_ENABLED BIT(6)
#define VINLOW_ENABLED BIT(0)
#define VINLOW_CTRL_REG_MASK GENMASK(7, 0)
/* USB Control Register
* Address : 0x40
*/
#define BOOST_OVP_DISABLED BIT(7)
#define VBUS_OTG_DETECTION_DISABLED BIT(6)
#define SW_OUT_DISCHARGE BIT(5)
#define VBUS_OTG_DISCHARGE BIT(4)
#define OCP_LIMIT_HIGH BIT(3)
#define SWIN_SWOUT_ENABLED BIT(2)
#define USBSW_OTG_SWITCH_ENABLED BIT(1)
#define BOOST_ENABLED BIT(0)
/* PKEY_TURNOFF_CR
* Address : 0x16
*/
#define PONKEY_PWR_OFF BIT(7)
#define PONKEY_CC_FLAG_CLEAR BIT(6)
#define PONKEY_TURNOFF_TIMER_MASK GENMASK(3, 0)
#define PONKEY_TURNOFF_MASK GENMASK(7, 0)
/*
* struct stpmic1 - stpmic1 master device for sub-drivers
* @dev: master device of the chip (can be used to access platform data)
* @irq: main IRQ number
* @regmap_irq_chip_data: irq chip data
*/
struct stpmic1 {
struct device *dev;
struct regmap *regmap;
int irq;
struct regmap_irq_chip_data *irq_data;
};
#endif /* __LINUX_MFD_STPMIC1_H */
|