Viewing file:  sdw_intel.h (8.75 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: (GPL-2.0 OR BSD-3-Clause) */
/* Copyright(c) 2015-17 Intel Corporation. */
#ifndef __SDW_INTEL_H
#define __SDW_INTEL_H
#include <linux/irqreturn.h>
#include <linux/soundwire/sdw.h>
#define SDW_SHIM_BASE 0x2C000
#define SDW_ALH_BASE 0x2C800
#define SDW_LINK_BASE 0x30000
#define SDW_LINK_SIZE 0x10000
/* Intel SHIM Registers Definition */
#define SDW_SHIM_LCAP 0x0
#define SDW_SHIM_LCTL 0x4
#define SDW_SHIM_IPPTR 0x8
#define SDW_SHIM_SYNC 0xC
#define SDW_SHIM_CTLSCAP(x) (0x010 + 0x60 * (x))
#define SDW_SHIM_CTLS0CM(x) (0x012 + 0x60 * (x))
#define SDW_SHIM_CTLS1CM(x) (0x014 + 0x60 * (x))
#define SDW_SHIM_CTLS2CM(x) (0x016 + 0x60 * (x))
#define SDW_SHIM_CTLS3CM(x) (0x018 + 0x60 * (x))
#define SDW_SHIM_PCMSCAP(x) (0x020 + 0x60 * (x))
#define SDW_SHIM_PCMSYCHM(x, y) (0x022 + (0x60 * (x)) + (0x2 * (y)))
#define SDW_SHIM_PCMSYCHC(x, y) (0x042 + (0x60 * (x)) + (0x2 * (y)))
#define SDW_SHIM_PDMSCAP(x) (0x062 + 0x60 * (x))
#define SDW_SHIM_IOCTL(x) (0x06C + 0x60 * (x))
#define SDW_SHIM_CTMCTL(x) (0x06E + 0x60 * (x))
#define SDW_SHIM_WAKEEN 0x190
#define SDW_SHIM_WAKESTS 0x192
#define SDW_SHIM_LCTL_SPA BIT(0)
#define SDW_SHIM_LCTL_SPA_MASK GENMASK(3, 0)
#define SDW_SHIM_LCTL_CPA BIT(8)
#define SDW_SHIM_LCTL_CPA_MASK GENMASK(11, 8)
#define SDW_SHIM_SYNC_SYNCPRD_VAL_24 (24000 / SDW_CADENCE_GSYNC_KHZ - 1)
#define SDW_SHIM_SYNC_SYNCPRD_VAL_38_4 (38400 / SDW_CADENCE_GSYNC_KHZ - 1)
#define SDW_SHIM_SYNC_SYNCPRD GENMASK(14, 0)
#define SDW_SHIM_SYNC_SYNCCPU BIT(15)
#define SDW_SHIM_SYNC_CMDSYNC_MASK GENMASK(19, 16)
#define SDW_SHIM_SYNC_CMDSYNC BIT(16)
#define SDW_SHIM_SYNC_SYNCGO BIT(24)
#define SDW_SHIM_PCMSCAP_ISS GENMASK(3, 0)
#define SDW_SHIM_PCMSCAP_OSS GENMASK(7, 4)
#define SDW_SHIM_PCMSCAP_BSS GENMASK(12, 8)
#define SDW_SHIM_PCMSYCM_LCHN GENMASK(3, 0)
#define SDW_SHIM_PCMSYCM_HCHN GENMASK(7, 4)
#define SDW_SHIM_PCMSYCM_STREAM GENMASK(13, 8)
#define SDW_SHIM_PCMSYCM_DIR BIT(15)
#define SDW_SHIM_PDMSCAP_ISS GENMASK(3, 0)
#define SDW_SHIM_PDMSCAP_OSS GENMASK(7, 4)
#define SDW_SHIM_PDMSCAP_BSS GENMASK(12, 8)
#define SDW_SHIM_PDMSCAP_CPSS GENMASK(15, 13)
#define SDW_SHIM_IOCTL_MIF BIT(0)
#define SDW_SHIM_IOCTL_CO BIT(1)
#define SDW_SHIM_IOCTL_COE BIT(2)
#define SDW_SHIM_IOCTL_DO BIT(3)
#define SDW_SHIM_IOCTL_DOE BIT(4)
#define SDW_SHIM_IOCTL_BKE BIT(5)
#define SDW_SHIM_IOCTL_WPDD BIT(6)
#define SDW_SHIM_IOCTL_CIBD BIT(8)
#define SDW_SHIM_IOCTL_DIBD BIT(9)
#define SDW_SHIM_CTMCTL_DACTQE BIT(0)
#define SDW_SHIM_CTMCTL_DODS BIT(1)
#define SDW_SHIM_CTMCTL_DOAIS GENMASK(4, 3)
#define SDW_SHIM_WAKEEN_ENABLE BIT(0)
#define SDW_SHIM_WAKESTS_STATUS BIT(0)
/* Intel ALH Register definitions */
#define SDW_ALH_STRMZCFG(x) (0x000 + (0x4 * (x)))
#define SDW_ALH_NUM_STREAMS 64
#define SDW_ALH_STRMZCFG_DMAT_VAL 0x3
#define SDW_ALH_STRMZCFG_DMAT GENMASK(7, 0)
#define SDW_ALH_STRMZCFG_CHN GENMASK(19, 16)
/**
* struct sdw_intel_stream_params_data: configuration passed during
* the @params_stream callback, e.g. for interaction with DSP
* firmware.
*/
struct sdw_intel_stream_params_data {
struct snd_pcm_substream *substream;
struct snd_soc_dai *dai;
struct snd_pcm_hw_params *hw_params;
int link_id;
int alh_stream_id;
};
/**
* struct sdw_intel_stream_free_data: configuration passed during
* the @free_stream callback, e.g. for interaction with DSP
* firmware.
*/
struct sdw_intel_stream_free_data {
struct snd_pcm_substream *substream;
struct snd_soc_dai *dai;
int link_id;
};
/**
* struct sdw_intel_ops: Intel audio driver callback ops
*
*/
struct sdw_intel_ops {
int (*params_stream)(struct device *dev,
struct sdw_intel_stream_params_data *params_data);
int (*free_stream)(struct device *dev,
struct sdw_intel_stream_free_data *free_data);
};
/**
* struct sdw_intel_acpi_info - Soundwire Intel information found in ACPI tables
* @handle: ACPI controller handle
* @count: link count found with "sdw-master-count" property
* @link_mask: bit-wise mask listing links enabled by BIOS menu
*
* this structure could be expanded to e.g. provide all the _ADR
* information in case the link_mask is not sufficient to identify
* platform capabilities.
*/
struct sdw_intel_acpi_info {
acpi_handle handle;
int count;
u32 link_mask;
};
struct sdw_intel_link_dev;
/* Intel clock-stop/pm_runtime quirk definitions */
/*
* Force the clock to remain on during pm_runtime suspend. This might
* be needed if Slave devices do not have an alternate clock source or
* if the latency requirements are very strict.
*/
#define SDW_INTEL_CLK_STOP_NOT_ALLOWED BIT(0)
/*
* Stop the bus during pm_runtime suspend. If set, a complete bus
* reset and re-enumeration will be performed when the bus
* restarts. This mode shall not be used if Slave devices can generate
* in-band wakes.
*/
#define SDW_INTEL_CLK_STOP_TEARDOWN BIT(1)
/*
* Stop the bus during pm_suspend if Slaves are not wake capable
* (e.g. speaker amplifiers). The clock-stop mode is typically
* slightly higher power than when the IP is completely powered-off.
*/
#define SDW_INTEL_CLK_STOP_WAKE_CAPABLE_ONLY BIT(2)
/*
* Require a bus reset (and complete re-enumeration) when exiting
* clock stop modes. This may be needed if the controller power was
* turned off and all context lost. This quirk shall not be used if a
* Slave device needs to remain enumerated and keep its context,
* e.g. to provide the reasons for the wake, report acoustic events or
* pass a history buffer.
*/
#define SDW_INTEL_CLK_STOP_BUS_RESET BIT(3)
struct sdw_intel_slave_id {
int link_id;
struct sdw_slave_id id;
};
/**
* struct sdw_intel_ctx - context allocated by the controller
* driver probe
* @count: link count
* @mmio_base: mmio base of SoundWire registers, only used to check
* hardware capabilities after all power dependencies are settled.
* @link_mask: bit-wise mask listing SoundWire links reported by the
* Controller
* @num_slaves: total number of devices exposed across all enabled links
* @handle: ACPI parent handle
* @ldev: information for each link (controller-specific and kept
* opaque here)
* @ids: array of slave_id, representing Slaves exposed across all enabled
* links
* @link_list: list to handle interrupts across all links
* @shim_lock: mutex to handle concurrent rmw access to shared SHIM registers.
* @shim_mask: flags to track initialization of SHIM shared registers
* @shim_base: sdw shim base.
* @alh_base: sdw alh base.
*/
struct sdw_intel_ctx {
int count;
void __iomem *mmio_base;
u32 link_mask;
int num_slaves;
acpi_handle handle;
struct sdw_intel_link_dev **ldev;
struct sdw_intel_slave_id *ids;
struct list_head link_list;
struct mutex shim_lock; /* lock for access to shared SHIM registers */
u32 shim_mask;
u32 shim_base;
u32 alh_base;
};
/**
* struct sdw_intel_res - Soundwire Intel global resource structure,
* typically populated by the DSP driver
*
* @count: link count
* @mmio_base: mmio base of SoundWire registers
* @irq: interrupt number
* @handle: ACPI parent handle
* @parent: parent device
* @ops: callback ops
* @dev: device implementing hwparams and free callbacks
* @link_mask: bit-wise mask listing links selected by the DSP driver
* This mask may be a subset of the one reported by the controller since
* machine-specific quirks are handled in the DSP driver.
* @clock_stop_quirks: mask array of possible behaviors requested by the
* DSP driver. The quirks are common for all links for now.
* @shim_base: sdw shim base.
* @alh_base: sdw alh base.
*/
struct sdw_intel_res {
int count;
void __iomem *mmio_base;
int irq;
acpi_handle handle;
struct device *parent;
const struct sdw_intel_ops *ops;
struct device *dev;
u32 link_mask;
u32 clock_stop_quirks;
u32 shim_base;
u32 alh_base;
};
/*
* On Intel platforms, the SoundWire IP has dependencies on power
* rails shared with the DSP, and the initialization steps are split
* in three. First an ACPI scan to check what the firmware describes
* in DSDT tables, then an allocation step (with no hardware
* configuration but with all the relevant devices created) and last
* the actual hardware configuration. The final stage is a global
* interrupt enable which is controlled by the DSP driver. Splitting
* these phases helps simplify the boot flow and make early decisions
* on e.g. which machine driver to select (I2S mode, HDaudio or
* SoundWire).
*/
int sdw_intel_acpi_scan(acpi_handle *parent_handle,
struct sdw_intel_acpi_info *info);
void sdw_intel_process_wakeen_event(struct sdw_intel_ctx *ctx);
struct sdw_intel_ctx *
sdw_intel_probe(struct sdw_intel_res *res);
int sdw_intel_startup(struct sdw_intel_ctx *ctx);
void sdw_intel_exit(struct sdw_intel_ctx *ctx);
void sdw_intel_enable_irq(void __iomem *mmio_base, bool enable);
irqreturn_t sdw_intel_thread(int irq, void *dev_id);
#define SDW_INTEL_QUIRK_MASK_BUS_DISABLE BIT(1)
#endif
|