Viewing file:  mxs-spi.h (4.8 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* include/linux/spi/mxs-spi.h
*
* Freescale i.MX233/i.MX28 SPI controller register definition
*
* Copyright 2008 Embedded Alley Solutions, Inc.
* Copyright 2009-2011 Freescale Semiconductor, Inc.
*/
#ifndef __LINUX_SPI_MXS_SPI_H__
#define __LINUX_SPI_MXS_SPI_H__
#include <linux/dmaengine.h>
#define ssp_is_old(host) ((host)->devid == IMX23_SSP)
/* SSP registers */
#define HW_SSP_CTRL0 0x000
#define BM_SSP_CTRL0_RUN (1 << 29)
#define BM_SSP_CTRL0_SDIO_IRQ_CHECK (1 << 28)
#define BM_SSP_CTRL0_LOCK_CS (1 << 27)
#define BM_SSP_CTRL0_IGNORE_CRC (1 << 26)
#define BM_SSP_CTRL0_READ (1 << 25)
#define BM_SSP_CTRL0_DATA_XFER (1 << 24)
#define BP_SSP_CTRL0_BUS_WIDTH 22
#define BM_SSP_CTRL0_BUS_WIDTH (0x3 << 22)
#define BM_SSP_CTRL0_WAIT_FOR_IRQ (1 << 21)
#define BM_SSP_CTRL0_WAIT_FOR_CMD (1 << 20)
#define BM_SSP_CTRL0_LONG_RESP (1 << 19)
#define BM_SSP_CTRL0_GET_RESP (1 << 17)
#define BM_SSP_CTRL0_ENABLE (1 << 16)
#define BP_SSP_CTRL0_XFER_COUNT 0
#define BM_SSP_CTRL0_XFER_COUNT 0xffff
#define HW_SSP_CMD0 0x010
#define BM_SSP_CMD0_DBL_DATA_RATE_EN (1 << 25)
#define BM_SSP_CMD0_SLOW_CLKING_EN (1 << 22)
#define BM_SSP_CMD0_CONT_CLKING_EN (1 << 21)
#define BM_SSP_CMD0_APPEND_8CYC (1 << 20)
#define BP_SSP_CMD0_BLOCK_SIZE 16
#define BM_SSP_CMD0_BLOCK_SIZE (0xf << 16)
#define BP_SSP_CMD0_BLOCK_COUNT 8
#define BM_SSP_CMD0_BLOCK_COUNT (0xff << 8)
#define BP_SSP_CMD0_CMD 0
#define BM_SSP_CMD0_CMD 0xff
#define HW_SSP_CMD1 0x020
#define HW_SSP_XFER_SIZE 0x030
#define HW_SSP_BLOCK_SIZE 0x040
#define BP_SSP_BLOCK_SIZE_BLOCK_COUNT 4
#define BM_SSP_BLOCK_SIZE_BLOCK_COUNT (0xffffff << 4)
#define BP_SSP_BLOCK_SIZE_BLOCK_SIZE 0
#define BM_SSP_BLOCK_SIZE_BLOCK_SIZE 0xf
#define HW_SSP_TIMING(h) (ssp_is_old(h) ? 0x050 : 0x070)
#define BP_SSP_TIMING_TIMEOUT 16
#define BM_SSP_TIMING_TIMEOUT (0xffff << 16)
#define BP_SSP_TIMING_CLOCK_DIVIDE 8
#define BM_SSP_TIMING_CLOCK_DIVIDE (0xff << 8)
#define BF_SSP_TIMING_CLOCK_DIVIDE(v) \
(((v) << 8) & BM_SSP_TIMING_CLOCK_DIVIDE)
#define BP_SSP_TIMING_CLOCK_RATE 0
#define BM_SSP_TIMING_CLOCK_RATE 0xff
#define BF_SSP_TIMING_CLOCK_RATE(v) \
(((v) << 0) & BM_SSP_TIMING_CLOCK_RATE)
#define HW_SSP_CTRL1(h) (ssp_is_old(h) ? 0x060 : 0x080)
#define BM_SSP_CTRL1_SDIO_IRQ (1 << 31)
#define BM_SSP_CTRL1_SDIO_IRQ_EN (1 << 30)
#define BM_SSP_CTRL1_RESP_ERR_IRQ (1 << 29)
#define BM_SSP_CTRL1_RESP_ERR_IRQ_EN (1 << 28)
#define BM_SSP_CTRL1_RESP_TIMEOUT_IRQ (1 << 27)
#define BM_SSP_CTRL1_RESP_TIMEOUT_IRQ_EN (1 << 26)
#define BM_SSP_CTRL1_DATA_TIMEOUT_IRQ (1 << 25)
#define BM_SSP_CTRL1_DATA_TIMEOUT_IRQ_EN (1 << 24)
#define BM_SSP_CTRL1_DATA_CRC_IRQ (1 << 23)
#define BM_SSP_CTRL1_DATA_CRC_IRQ_EN (1 << 22)
#define BM_SSP_CTRL1_FIFO_UNDERRUN_IRQ (1 << 21)
#define BM_SSP_CTRL1_FIFO_UNDERRUN_IRQ_EN (1 << 20)
#define BM_SSP_CTRL1_RECV_TIMEOUT_IRQ (1 << 17)
#define BM_SSP_CTRL1_RECV_TIMEOUT_IRQ_EN (1 << 16)
#define BM_SSP_CTRL1_FIFO_OVERRUN_IRQ (1 << 15)
#define BM_SSP_CTRL1_FIFO_OVERRUN_IRQ_EN (1 << 14)
#define BM_SSP_CTRL1_DMA_ENABLE (1 << 13)
#define BM_SSP_CTRL1_PHASE (1 << 10)
#define BM_SSP_CTRL1_POLARITY (1 << 9)
#define BP_SSP_CTRL1_WORD_LENGTH 4
#define BM_SSP_CTRL1_WORD_LENGTH (0xf << 4)
#define BF_SSP_CTRL1_WORD_LENGTH(v) \
(((v) << 4) & BM_SSP_CTRL1_WORD_LENGTH)
#define BV_SSP_CTRL1_WORD_LENGTH__FOUR_BITS 0x3
#define BV_SSP_CTRL1_WORD_LENGTH__EIGHT_BITS 0x7
#define BV_SSP_CTRL1_WORD_LENGTH__SIXTEEN_BITS 0xF
#define BP_SSP_CTRL1_SSP_MODE 0
#define BM_SSP_CTRL1_SSP_MODE 0xf
#define BF_SSP_CTRL1_SSP_MODE(v) \
(((v) << 0) & BM_SSP_CTRL1_SSP_MODE)
#define BV_SSP_CTRL1_SSP_MODE__SPI 0x0
#define BV_SSP_CTRL1_SSP_MODE__SSI 0x1
#define BV_SSP_CTRL1_SSP_MODE__SD_MMC 0x3
#define BV_SSP_CTRL1_SSP_MODE__MS 0x4
#define HW_SSP_DATA(h) (ssp_is_old(h) ? 0x070 : 0x090)
#define HW_SSP_SDRESP0(h) (ssp_is_old(h) ? 0x080 : 0x0a0)
#define HW_SSP_SDRESP1(h) (ssp_is_old(h) ? 0x090 : 0x0b0)
#define HW_SSP_SDRESP2(h) (ssp_is_old(h) ? 0x0a0 : 0x0c0)
#define HW_SSP_SDRESP3(h) (ssp_is_old(h) ? 0x0b0 : 0x0d0)
#define HW_SSP_STATUS(h) (ssp_is_old(h) ? 0x0c0 : 0x100)
#define BM_SSP_STATUS_CARD_DETECT (1 << 28)
#define BM_SSP_STATUS_SDIO_IRQ (1 << 17)
#define BM_SSP_STATUS_FIFO_EMPTY (1 << 5)
#define BF_SSP(value, field) (((value) << BP_SSP_##field) & BM_SSP_##field)
#define SSP_PIO_NUM 3
enum mxs_ssp_id {
IMX23_SSP,
IMX28_SSP,
};
struct mxs_ssp {
struct device *dev;
void __iomem *base;
struct clk *clk;
unsigned int clk_rate;
enum mxs_ssp_id devid;
struct dma_chan *dmach;
unsigned int dma_dir;
enum dma_transfer_direction slave_dirn;
u32 ssp_pio_words[SSP_PIO_NUM];
};
void mxs_ssp_set_clk_rate(struct mxs_ssp *ssp, unsigned int rate);
#endif /* __LINUX_SPI_MXS_SPI_H__ */
|